Elpro Technologies 105U-G Spécifications télécharger pdf (Page 41)

Application Note 105U-G-PR2 Profibus Master

Issue 1.2 – May 2005

©ELPRO Technologies Pty Ltd

Page 3 of 13

app_105U-G_PR2_1.2.doc

Open the “+”next to the name of the Profibus Slave device on the left hand tree window and drag

the I/O modules installed in the device over to the right hand window and drop them into the

appropriate slots. (See below) Making sure that all modules are present including any power

supply modules etc. Add each slot as you see them on the slave device.

In the above example we have setup 2 digital inputs and 2 digital outputs. If a module is selected

from the list provided, all of the addressing is done for you. If the I/O module is not present or is

a special type you can add a “universal module” and assign the start address, length type, etc.

Ensure you add all the slots configured for the slave device including power supplies and

configuration slots if used.

When all I/O has

been added, close the

Profibus Network

Configuration

window which will

bring you back to the

E-Series

Configuration

window.

Select “Fieldbus

Config“ see below.

Gateway

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 65 66

Pas de commentaire

Elpro Technologies 105U-G Spécifications Page 41